Keysight Technologies InfiniiVision 4000 X Series

:SBUS<n> Commands 31
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 915
:SBUS<n>:CXPI:TRIGger:IDFilter
(see page 1610)
Command Syntax
:SBUS<n>:CXPI:TRIGger:IDFilter {{0 | OFF} | {1 | ON}}
When triggering on CRC Field Errors, Inter-Byte Space Errors, Framing Errors, or
Data Length Errors, the :SBUS<n>:CXPI:TRIGger:IDFilter command lets you
enable/disable modification of the trigger so that it occurs only for a specified ID.
Query Syntax
:SBUS<n>:CXPI:TRIGger:IDFilter?
The :SBUS<n>:CXPI:TRIGger:IDFilter? query returns the ID filter setting.
Return Format
<setting><NL>
<setting> ::= {0 | 1}
See Also • ":SBUS<n>:CXPI:TRIGger" on page 913
• ":SBUS<n>:CXPI:TRIGger:PTYPe" on page 916
• ":SBUS<n>:CXPI:TRIGger:PATTern:DATA" on page 917
• ":SBUS<n>:CXPI:TRIGger:PATTern:DATA:LENGth" on page 918
• ":SBUS<n>:CXPI:TRIGger:PATTern:DATA:STARt" on page 919
• ":SBUS<n>:CXPI:TRIGger:PATTern:ID" on page 920
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:CT" on page 921
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:DLC" on page 922
• ":SBUS<n>:CXPI:TRIGger:PATTern:INFO:NM" on page 923