Keysight Technologies InfiniiVision 4000 X Series User Manual

:WGEN<w> Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1445
:WGEN<w>:FREQuency
(see page 1610)
Command Syntax
:WGEN<w>:FREQuency <frequency>
<w> ::= 1 to (# WaveGen outputs) in NR1 format
<frequency> ::= frequency in Hz in NR3 format
For all waveforms except Noise and DC, the :WGEN<w>:FREQuency command
specifies the frequency of the waveform.
You can also specify the frequency indirectly using the :WGEN<w>:PERiod
command.
Query Syntax
:WGEN<w>:FREQuency?
The :WGEN<w>:FREQuency? query returns the currently set waveform generator
frequency.
Return Format
<frequency><NL>
<frequency> ::= frequency in Hz in NR3 format
See Also • "Introduction to :WGEN<w> Commands" on page 1435
• ":WGEN<w>:FUNCtion" on page 1446
• ":WGEN<w>:PERiod" on page 1470

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English