Keysight Technologies InfiniiVision 4000 X Series

1148 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:USBPd:TRIGger:HEADer:QUALifier
(see page 1610)
Command Syntax
:SBUS<n>:USBPd:TRIGger:HEADer:QUALifier <type>
<type> ::= {NONE | SOP | SPRime | SDPRime}
When the Header Content trigger mode is selected (with the
":SBUS<n>:USBPd:TRIGger HEADer" command), the
:SBUS<n>:USBPd:TRIGger:HEADer:QUALifier command selects an additional
qualifier for the Header Content trigger:
•NONE — None. There is no additional qualifier for the trigger.
•SOP — SOP. The trigger occurs on Sync-1, Sync-1, Sync-1, Sync-2 ordered sets
only.
•SPRime — SOP'. The trigger occurs on Sync-1, Sync-1, Sync-3, Sync-3 ordered
sets only.
• SDPRime — SOP''. The trigger occurs on Sync-1, Sync-3, Sync-1, Sync-3
ordered sets only.
Query Syntax
:SBUS<n>:USBPd:TRIGger:HEADer:QUALifier?
The :SBUS<n>:USBPd:TRIGger:HEADer:QUALifier? query returns the selected
header content trigger qualifier.
Return Format
<type><NL>
<type> ::= {NONE | SOP | SPRime | SDPRime}
See Also • ":SBUS<n>:USBPd:SOURce" on page 1138
• ":SBUS<n>:USBPd:TRIGger" on page 1139
• ":SBUS<n>:USBPd:TRIGger:HEADer" on page 1140
• ":SBUS<n>:USBPd:TRIGger:HEADer:CMESsage" on page 1142
• ":SBUS<n>:USBPd:TRIGger:HEADer:DMESsage" on page 1144
• ":SBUS<n>:USBPd:TRIGger:HEADer:EMESsage" on page 1145
• ":SBUS<n>:USBPd:TRIGger:HEADer:VALue" on page 1147