To Next Page

To Previous Page

:POWer Commands 28

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 765

:POWer:PSRR:FREQuency:MODE

(see page 1610)

Command Syntax

:POWer:PSRR:FREQuency:MODE <mode>

<mode> ::= {SWEep | SINGle}

The :POWer:PSRR:FREQuency:MODE command specifies whether the analysis

should be performed by sweeping through a range of frequencies (SWEep) or at a

single frequency (SINGle).

The SINGle mode is useful for evaluating amplitudes at a single frequency. After

running the test at a single frequency, you can manually adjust (increase) the

waveform generator's amplitude until you begin to observe distortion in the

waveforms on the oscilloscope's display. You can then use that amplitude at all

frequencies in SWEep mode, or you can evaluate amplitudes at other frequencies

in order to determine an optimized amplitude profile (see

:POWer:PSRR:WGEN:VOLTage:PROFile).

Query Syntax

:POWer:CLResponse:FREQuency:MODE?

The :POWer:PSRR:FREQuency:MODE? query returns the frequency mode setting.

Return Format

<mode> ::= {SWE | SING}

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: