:SAVE Commands 30
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 827
:SAVE:FILename
(see page 1610)
Command Syntax
:SAVE:FILename <base_name>
<base_name> ::= quoted ASCII string
The :SAVE:FILename command specifies the source for any SAVE operations.
Query Syntax
:SAVE:FILename?
The :SAVE:FILename? query returns the current SAVE filename.
Return Format
<base_name><NL>
<base_name> ::= quoted ASCII string
See Also • "Introduction to :SAVE Commands" on page 824
• ":SAVE:IMAGe[:STARt]" on page 828
• ":SAVE[:SETup[:STARt]]" on page 844
• ":SAVE:WAVeform[:STARt]" on page 845
• ":SAVE:PWD" on page 837
• ":RECall:FILename" on page 814
This command specifies a file's base name only, without path information or an extension.
To Next Page
Loading...
