Keysight Technologies InfiniiVision 4000 X Series User Manual

:MEASure Commands 24
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 619
:MEASure:STATistics:INCRement
(see page 1610)
Command Syntax
:MEASure:STATistics:INCRement
This command updates the statistics once (incrementing the count by one) using
the current measurement values. It corresponds to the front panel Increment
Statistics softkey in the Measurement Statistics Menu. This command lets you, for
example, gather statistics over multiple pulses captured in a single acquisition. To
do this, change the horizontal position and enter the command for each new pulse
that is measured.
This command is only allowed when the oscilloscope is stopped and quick
measurements are on.
The command is allowed in segmented acquisition mode even though the
corresponding front panel softkey is not available.
See Also • "Introduction to :MEASure Commands" on page 568
• ":MEASure:STATistics" on page 617
• ":MEASure:STATistics:DISPlay" on page 618
• ":MEASure:STATistics:RESet" on page 621
• ":MEASure:RESults" on page 608

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English