To Next Page

To Previous Page

:MEASure Commands 24

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 583

:MEASure:DUAL:CHARge

(see page 1610)

Overview This measurement is available with the N2820A high sensitivity current probe

when both the Primary and Secondary probe cables are used. This measurement

joins the Zoom In waveform data below the probe's clamp level with Zoom Out

waveform data above the probe's clamp level to create the waveform on which the

measurement is made.

Command Syntax

:MEASure:DUAL:CHARge [<interval>][,<source1>][,<source2>]

<interval> ::= {CYCLe | DISPlay}

<source1>,<source2> ::= CHANnel<n> with N2820A probe connected

<n> ::= 1 to (# analog channels) in NR1 format

The :MEASure:DUAL:CHARge command installs a charge measurement on screen.

Charge measurements show the area between the waveform and the ground level.

The <interval> option lets you specify the measurement interval: either an integral

number of cycles, or the full screen. If <interval> is not specified, DISPlay is

implied.

If the optional source parameter(s) are specified, the currently specified source(s)

are modified.

Query Syntax

:MEASure:DUAL:CHARge? [<interval>][,<source1>][,<source2>]

The :MEASure:DUAL:CHARge? query measures and returns the charge

measurement value.

Return Format

<value> ::= the charge value in Amp-hours in NR3 format

See Also • ":MEASure:DUAL:VAMPlitude" on page 584

• ":MEASure:DUAL:VAVerage" on page 585

• ":MEASure:DUAL:VBASe" on page 586

• ":MEASure:DUAL:VPP" on page 587

• ":MEASure:DUAL:VRMS" on page 588

• "Introduction to :MEASure Commands" on page 568

• ":MEASure:SOURce" on page 615

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: