To Next Page

To Previous Page

1042 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide

31 :SBUS<n> Commands

:SBUS<n>:SENT:DISPlay

(see page 1610)

Command Syntax

:SBUS<n>:SENT:DISPlay <base>

<base> ::= {HEX | DECimal | SYMBolic}

The :SBUS<n>:SENT:DISPlay command specifies the number base used by the

decoder. The chosen base is used for the data nibbles in Raw decode format, the

defined Signals in the other formats, and for the data field of the Serial Messages.

This selection is used for both the Lister and the decode line displays.

When SYMBolic is selected, Fast Channel Signals display a calculated physical

value based on the specified multiplier and offset:

• PhysicalValue = (Multiplier * SignalValueAsUnsignedInteger) + Offset

When SYMBolic is selected, the CRC and Slow Channel information is displayed in

hex.

Query Syntax

:SBUS<n>:SENT:DISPlay?

The :SBUS<n>:SENT:DISPlay? query returns the SENT decode number base

setting.

Return Format

<base> ::= {HEX | DEC | SYMB}

See Also • ":SBUS<n>:SENT:CLOCk" on page 1040

• ":SBUS<n>:SENT:CRC" on page 1041

• ":SBUS<n>:SENT:FORMat" on page 1044

• ":SBUS<n>:SENT:IDLE" on page 1046

• ":SBUS<n>:SENT:LENGth" on page 1047

• ":SBUS<n>:SENT:PPULse" on page 1048

• ":SBUS<n>:SENT:SIGNal<s>:DISPlay" on page 1050

• ":SBUS<n>:SENT:SIGNal<s>:LENGth" on page 1051

• ":SBUS<n>:SENT:SIGNal<s>:MULTiplier" on page 1053

• ":SBUS<n>:SENT:SIGNal<s>:OFFSet" on page 1055

• ":SBUS<n>:SENT:SIGNal<s>:ORDer" on page 1057

• ":SBUS<n>:SENT:SIGNal<s>:STARt" on page 1059

• ":SBUS<n>:SENT:SOURce" on page 1061

• ":SBUS<n>:SENT:TOLerance" on page 1063

• ":SBUS<n>:SENT:TRIGger" on page 1064

• ":SBUS<n>:SENT:TRIGger:FAST:DATA" on page 1066

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: