:POWer Commands 28
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 807
:POWer:TRANsient:NEXT
(see page 1610)
Command Syntax
:POWer:TRANsient:NEXT
The :POWer:TRANsient:NEXT command goes to the next step of the transient
analysis.
This command is equivalent to pressing the Next softkey on the oscilloscope front
panel when prompted during the analysis.
See Also • ":POWer:TRANsient:APPLy" on page 803
• ":POWer:TRANsient:EXIT" on page 804
• ":POWer:TRANsient:IINitial" on page 805
• ":POWer:TRANsient:INEW" on page 806
To Next Page
Loading...
