Keysight Technologies InfiniiVision 4000 X Series User Manual

:WGEN<w> Commands 37
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1459
:WGEN<w>:MODulation:FUNCtion
(see page 1610)
Command Syntax
:WGEN<w>:MODulation:FUNCtion <shape>
<w> ::= 1 in NR1 format
<shape> ::= {SINusoid | SQUare| RAMP}
The :WGEN<w>:MODulation:FUNCtion command specifies the shape of the
modulating signal.
When the RAMP shape is selected, you can specify the amount of time per cycle
that the ramp waveform is rising with the
:WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry command.
This command applies to AM and FM modulation. (The FSK modulation signal is a
square wave shape.)
Query Syntax
:WGEN<w>:MODulation:FUNCtion?
The :WGEN<w>:MODulation:FUNCtion? query returns the specified modulating
signal shape.
Return Format
<shape><NL>
<shape> ::= {SIN | SQU| RAMP}
See Also • ":WGEN<w>:MODulation:AM:DEPTh" on page 1453
• ":WGEN<w>:MODulation:AM:FREQuency" on page 1454
• ":WGEN<w>:MODulation:FM:DEViation" on page 1455
• ":WGEN<w>:MODulation:FM:FREQuency" on page 1456
• ":WGEN<w>:MODulation:FSKey:FREQuency" on page 1457
• ":WGEN<w>:MODulation:FSKey:RATE" on page 1458
• ":WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry" on page 1460
• ":WGEN<w>:MODulation:STATe" on page 1462
• ":WGEN<w>:MODulation:TYPE" on page 1463

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English