:SEARch Commands 32
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1197
:SEARch:SERial:FLEXray:CYCLe
(see page 1610)
Command Syntax
:SEARch:SERial:FLEXray:CYCLe <cycle>
<cycle> ::= {ALL | <cycle #>}
<cycle #> ::= integer from 0-63
The :SEARch:SERial:FLEXray:CYCLe command specifies the cycle value to find
when searching for FlexRay frames.
A cycle value of -1 is the same as ALL.
Query Syntax
:SEARch:SERial:FLEXray:CYCLe?
The :SEARch:SERial:FLEXray:CYCLe? query returns the current cycle value setting.
Return Format
<cycle><NL>
<cycle> ::= {ALL | <cycle #>}
<cycle #> ::= integer from 0-63
See Also • Chapter 32, “:SEARch Commands,” starting on page 1149
• ":SEARch:SERial:FLEXray:MODE" on page 1201