Keysight Technologies InfiniiVision 4000 X Series

1120 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
31 :SBUS<n> Commands
:SBUS<n>:USB:TRIGger
(see page 1610)
Command Syntax
:SBUS<n>:USB:TRIGger <condition>
<condition> ::= {SOP | EOP | ENTersuspend | EXITsuspend | RESet
| TOKen | DATA | HANDshake | SPECial | ALLerrors
| PIDerror | CRC5error | CRC16error | GLITcherror
| STUFFerror | SE1error}
The :SBUS<n>:USB:TRIGger command specifies the USB trigger mode for the
selected bus.
Query Syntax
:SBUS<n>:USB:TRIGger?
The :SBUS<n>:USB:TRIGger? query returns the specified USB trigger mode.
Return Format
<condition><NL>
<condition> ::= {SOP | EOP | ENT | EXIT | RES | TOK | DATA | HAND
| SPEC | ALL | PID | CRC5 | CRC16 | GLIT | STUFF
|SE1}
See Also • ":SBUS<n>:USB:TRIGger:PID:DATA" on page 1130
• ":SBUS<n>:USB:TRIGger:PID:HANDshake" on page 1131
• ":SBUS<n>:USB:TRIGger:PID:SPECial" on page 1132
• ":SBUS<n>:USB:TRIGger:PID:TOKen" on page 1133