To Next Page

To Previous Page

980 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide

31 :SBUS<n> Commands

:SBUS<n>:LIN:STANdard

(see page 1610)

Command Syntax

:SBUS<n>:LIN:STANdard <std>

<std> ::= {LIN13 | LIN13NLC | LIN20}

The :SBUS<n>:LIN:STANdard command sets the LIN standard in effect for

triggering and decoding:

• LIN13 — LIN 1.3.

• LIN13NLC — LIN 1.3 (no length control). Select this for systems where length

control is not used and all nodes have knowledge of the data packet size. In LIN

1.3, the ID may or may not be used to indicate the number of bytes. (In LIN 2.X,

there is no length control.)

• LIN20 — LIN 2.X.

For LIN 1.2 signals, use the LIN 1.3 setting. The LIN 1.3 setting assumes the signal

follows the "Table of Valid ID Values" as shown in section A.2 of the LIN

Specification dated December 12, 2002. If your signal does not comply with the

table, use the LIN 2.X setting.

Query Syntax

:SBUS<n>:LIN:STANdard?

The :SBUS<n>:LIN:STANdard? query returns the current LIN standard setting.

Return Format

<std> ::= {LIN13 | LIN13NLC | LIN20}

See Also • "Introduction to :TRIGger Commands" on page 1295

• ":TRIGger:MODE" on page 1308

• ":SBUS<n>:LIN:SIGNal:DEFinition" on page 1543

• ":SBUS<n>:LIN:SOURce" on page 979

Keysight Technologies InfiniiVision 4000 X Series User Manual

Questions and Answers: