1456 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
37 :WGEN<w> Commands
:WGEN<w>:MODulation:FM:FREQuency
(see page 1610)
Command Syntax
:WGEN<w>:MODulation:FM:FREQuency <frequency>
<w> ::= 1 in NR1 format
<frequency> ::= modulating waveform frequency in Hz in NR3 format
The :WGEN<w>:MODulation:FM:FREQuency command specifies the frequency of
the modulating signal.
Query Syntax
:WGEN<w>:MODulation:FM:FREQuency?
The :WGEN<w>:MODulation:FM:FREQuency? query returns the frequency of the
modulating signal.
Return Format
<frequency><NL>
<frequency> ::= modulating waveform frequency in Hz in NR3 format
See Also • ":WGEN<w>:MODulation:AM:DEPTh" on page 1453
• ":WGEN<w>:MODulation:AM:FREQuency" on page 1454
• ":WGEN<w>:MODulation:FM:DEViation" on page 1455
• ":WGEN<w>:MODulation:FSKey:FREQuency" on page 1457
• ":WGEN<w>:MODulation:FSKey:RATE" on page 1458
• ":WGEN<w>:MODulation:FUNCtion" on page 1459
• ":WGEN<w>:MODulation:FUNCtion:RAMP:SYMMetry" on page 1460
• ":WGEN<w>:MODulation:STATe" on page 1462
• ":WGEN<w>:MODulation:TYPE" on page 1463
To Next Page
Loading...
