Keysight Technologies InfiniiVision 4000 X Series User Manual

1284 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
34 :TIMebase Commands
:TIMebase:POSition
(see page 1610)
Command Syntax
:TIMebase:POSition <pos>
<pos> ::= time in seconds from the trigger to the display reference
in NR3 format
The :TIMebase:POSition command sets the time interval between the trigger event
and the display reference point on the screen. The display reference point is either
left, right, or center and is set with the :TIMebase:REFerence command. The
maximum position value depends on the time/division settings.
Query Syntax
:TIMebase:POSition?
The :TIMebase:POSition? query returns the current time from the trigger to the
display reference in seconds.
Return Format
<pos><NL>
<pos> ::= time in seconds from the trigger to the display reference
in NR3 format
See Also • "Introduction to :TIMebase Commands" on page 1282
• ":TIMebase:REFerence" on page 1287
• ":TIMebase:RANGe" on page 1285
• ":TIMebase:SCALe" on page 1289
• ":TIMebase:WINDow:POSition" on page 1291
• ":TIMebase:DELay" on page 1546
NOTE
This command is an alias for the :TIMebase:DELay command.

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English