Keysight Technologies InfiniiVision 4000 X Series User Manual

:MEASure Commands 24
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 597
:MEASure:NEDGes
(see page 1610)
Command Syntax
:MEASure:NEDGes [<source>]
<source> ::= {CHANnel<n> | FUNCtion<m> | MATH<m> | WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<m> ::= 1 to (# math functions) in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
The :MEASure:NEDGes command installs a falling edge count measurement on
screen. If the optional source parameter is not specified, the current source is
measured.
Query Syntax
:MEASure:NEDGes? [<source>]
The :MEASure:NEDGes? query measures and returns the on-screen falling edge
count.
Return Format
<value><NL>
<value> ::= the falling edge count in NR3 format
See Also • "Introduction to :MEASure Commands" on page 568
• ":MEASure:SOURce" on page 615
NOTE
This command is not available if the source is FFT (Fast Fourier Transform).

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English