Keysight Technologies InfiniiVision 4000 X Series - Page 295

Root (:) Commands 7
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 295
:STOP
(see page 1610)
Command Syntax
:STOP
The :STOP command stops the acquisition. This is the same as pressing the Stop
key on the front panel.
See Also • "Introduction to Root (:) Commands" on page 258
• ":RUN" on page 291
• ":SINGle" on page 293
Example Code • "Example Code" on page 291