Keysight Technologies InfiniiVision 4000 X Series

Commands Quick Reference 5
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 111
:COUNter:NDIGits
<value> (see page 383)
:COUNter:NDIGits (see
page 383)
<value> ::= 5 normally, 8 with
10 MHz reference signal, in NR1
format
:COUNter:SOURce
<source> (see
page 384)
:COUNter:SOURce? (see
page 384)
<source> ::= {CHANnel<n> |
TQEVent}
<n> ::= 1 to (# analog channels)
in NR1 format
Table 9 :COUNter Commands Summary (continued)
Command Query Options and Query Returns
Table 10 :DEMO Commands Summary
Command Query Options and Query Returns
:DEMO:FUNCtion
<signal> (see
page 386)
:DEMO:FUNCtion? (see
page 389)
<signal> ::= {SINusoid | NOISy |
PHASe | RINGing | SINGle | AM |
CLK | GLITch | BURSt | MSO | RUNT
| TRANsition | RFBurst | SHOLd |
LFSine | FMBurst | ETE | CAN |
LIN | UART | I2C | SPI | I2S |
CANLin | CXPI | ARINc | FLEXray |
MIL | MIL2 | USB | NMONotonic}
:DEMO:FUNCtion:PHASe:
PHASe <angle> (see
page 391)
:DEMO:FUNCtion:PHASe:
PHASe? (see page 391)
<angle> ::= angle in degrees from
0 to 360 in NR3 format
:DEMO:OUTPut {{0 |
OFF} | {1 | ON}} (see
page 392)
:DEMO:OUTPut? (see
page 392)
{0 | 1}
Table 11 :DIGital<d> Commands Summary
Command Query Options and Query Returns
:DIGital<d>:DISPlay
{{0 | OFF} | {1 |
ON}} (see page 395)
:DIGital<d>:DISPlay?
(see page 395)
<d> ::= 0 to (# digital channels
- 1) in NR1 format
{0 | 1}
:DIGital<d>:LABel
<string> (see
page 396)
:DIGital<d>:LABel?
(see page 396)
<d> ::= 0 to (# digital channels
- 1) in NR1 format
<string> ::= any series of 10 or
less ASCII characters enclosed in
quotation marks