Keysight Technologies InfiniiVision 4000 X Series

Programming Examples 44
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1731
myScope.SCPI.WAVeform.POINts.MODE.Command("RAW");
myScope.SCPI.WAVeform.POINts.MODE.Query(out strResults);
Console.WriteLine("Waveform points mode: {0}", strResults);
// Get the number of waveform points available.
myScope.SCPI.WAVeform.POINts.CommandPoints(10240);
int nPointsAvail;
myScope.SCPI.WAVeform.POINts.Query1(out nPointsAvail);
Console.WriteLine("Waveform points available: {0}", nPointsAvail);
// Set the waveform source.
myScope.SCPI.WAVeform.SOURce.Command("CHANnel1");
myScope.SCPI.WAVeform.SOURce.Query(out strResults);
Console.WriteLine("Waveform source: {0}", strResults);
// Choose the format of the data returned (WORD, BYTE, ASCII):
myScope.SCPI.WAVeform.FORMat.Command("BYTE");
myScope.SCPI.WAVeform.FORMat.Query(out strResults);
Console.WriteLine("Waveform format: {0}", strResults);
// Display the waveform settings:
int nFormat, nType, nPoints, nCount, nXreference, nYreference;
double dblXincrement, dblXorigin, dblYincrement, dblYorigin;
myScope.SCPI.WAVeform.PREamble.Query(
out nFormat,
out nType,
out nPoints,
out nCount,
out dblXincrement,
out dblXorigin,
out nXreference,
out dblYincrement,
out dblYorigin,
out nYreference);
if (nFormat == 0)
{
Console.WriteLine("Waveform format: BYTE");
}
else if (nFormat == 1)
{
Console.WriteLine("Waveform format: WORD");
}
else if (nFormat == 2)
{
Console.WriteLine("Waveform format: ASCii");
}
if (nType == 0)
{
Console.WriteLine("Acquire type: NORMal");
}
else if (nType == 1)
{
Console.WriteLine("Acquire type: PEAK");
}
else if (nType == 2)