Keysight Technologies InfiniiVision 4000 X Series

Obsolete and Discontinued Commands 39
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1495
Discontinued
Commands
Discontinued commands are commands that were used by previous oscilloscopes,
but are not supported by the InfiniiVision 4000 X-Series oscilloscopes. Listed
below are the Discontinued commands and the nearest equivalent command
available (if any).
:TRIGger:THReshold (see
page 1547)
:POD<n>:THReshold (see
page 703) or
:DIGital<d>:THReshold (see
page 399)
:TRIGger:TV:TVMode (see
page 1548)
:TRIGger:TV:MODE (see
page 1378)
Obsolete Command Current Command Equivalent Behavior Differences
Discontinued Command Current Command Equivalent Comments
ASTore :DISPlay:PERSistence INFinite
(see page 422)
CHANnel:MATH :FUNCtion:OPERation (see
page 490)
ADD not included
CHANnel<n>:PROTect :CHANnel<n>:PROTection (see
page 362)
Previous form of this command
was used to enable/disable
50Ω protection. The new
command resets a tripped
protect and the query returns
the status of TRIPed or
NORMal.
DISPlay:INVerse none
DISPlay:COLumn none
DISPlay:FREeze none
DISPlay:GRID none
DISPLay:LINE none
DISPlay:PIXel none
DISPlay:POSition none
DISPlay:ROW none
DISPlay:TEXT none
FUNCtion:MOVE none
FUNCtion:PEAKs none
HARDcopy:ADDRess none Only parallel printer port is
supported. GPIB printing not
supported