1496 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
39 Obsolete and Discontinued Commands
MASK none All commands discontinued,
feature not available
:POWer:SIGNals:CYCLes :POWer:SIGNals:CYCLes:HARM
onics (see page 777)
:POWer:SIGNals:CYCLes:QUALi
ty (see page 778)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:DURation :POWer:SIGNals:DURation:EFFi
ciency (see page 779)
:POWer:SIGNals:DURation:MO
Dulation (see page 780)
:POWer:SIGNals:DURation:ON
OFf:OFF (see page 781)
:POWer:SIGNals:DURation:ON
OFf:ON (see page 782)
:POWer:SIGNals:DURation:RIP
Ple (see page 783)
:POWer:SIGNals:DURation:TRA
Nsient (see page 784)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:VMAXimum :POWer:SIGNals:VMAXimum:IN
Rush (see page 787)
:POWer:SIGNals:VMAXimum:O
NOFf:OFF (see page 788)
:POWer:SIGNals:VMAXimum:O
NOFf:ON (see page 789)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SIGNals:VSTeady :POWer:SIGNals:VSTeady:ONO
Ff:OFF (see page 790)
:POWer:SIGNals:VSTeady:ONO
Ff:ON (see page 791)
:POWer:SIGNals:VSTeady:TRA
Nsient (see page 792)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SLEW:VALue none Slew rate values are now
displayed using max and min
measurements of a
differentiate math function
signal.
:PWRenable none The Power Event Enable
Register does not exist in the
4000 X-Series oscilloscopes.
:PWRRegister[:EVENt] none The Power Event Event
Register does not exist in the
4000 X-Series oscilloscopes.
Discontinued Command Current Command Equivalent Comments
To Next Page
Loading...
