Obsolete and Discontinued Commands 39
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 1497
Discontinued
Parameters
Some previous oscilloscope queries returned control setting values of OFF and ON.
The InfiniiVision 4000 X-Series oscilloscopes only return the enumerated values 0
(for off) and 1 (for on).
SYSTem:KEY none
TEST:ALL *TST (Self Test) (see
page 253)
TRACE subsystem none All commands discontinued,
feature not available
TRIGger:ADVanced subsystem Use new GLITch, PATTern, or TV
trigger modes
TRIGger:TV:FIELd :TRIGger:TV:MODE (see
page 1378)
TRIGger:TV:TVHFrej
TRIGger:TV:VIR none
:TRIGger:USB:SOURce:DMINus none These USB trigger commands
are superseded by commands
that are available with the USB
2.0 Full/Low Speed or USB 2.0
High Speed serial decode and
triggering licenses. See
":SBUS<n>:USB
Commands" on page 1112.
:TRIGger:USB:SOURce:DPLus none
:TRIGger:USB:SPEed none
:TRIGger:USB:TRIGger none
VAUToscale none
Discontinued Command Current Command Equivalent Comments
To Next Page
Loading...
