Keysight Technologies InfiniiVision 4000 X Series - Page 45

What's New 1
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 45
Changed
Commands
:MEASure:FFT:ACPR (see
page 591)
Installs an FFT analysis Adjacent Channel Power Ratio (ACPR)
measurement on screen or returns the measured value.
:MEASure:FFT:CPOWer (see
page 592)
Installs an FFT analysis Channel Power measurement on screen or
returns the measured value.
:MEASure:FFT:OBW (see
page 593)
Installs an FFT analysis Occupied Bandwidth measurement on
screen or returns the measured value.
:MEASure:FFT:THD (see
page 594)
Installs an FFT analysis Total Harmonic Distortion measurement
on screen or returns the measured value.
:SBUS<n>:MANChester
Commands (see page 999)
Commands for using the Manchester triggering and serial decode
feature.
:SBUS<n>:NRZ Commands
(see page 1018)
Commands for using the NRZ triggering and serial decode
feature.
:TRIGger:HOLDoff:MAXimum
(see page 1302)
When the random trigger holdoff mode is enabled, this command
specifies the maximum trigger holdoff time.
:TRIGger:HOLDoff:MINimum
(see page 1303)
When the random trigger holdoff mode is enabled, this command
specifies the minimum trigger holdoff time.
:TRIGger:HOLDoff:RANDom
(see page 1304)
Enables or disables the random trigger holdoff mode.
:TRIGger:NFC:RPOLarity (see
page 1342)
Enables or disables triggering on signals with "reverse" polarity.
Command Description
Command Differences
:CALibrate:OUTPut (see
page 335)
The TSOurce option can now be selected to output the raw trigger
signal from the oscilloscope's trigger circuit to Trig Out.
:CHANnel<n>:PROBe:HEAD:TY
PE (see page 355)
The DSMA and DSMA6 probe head types can now be selected.
:DEMO:FUNCtion (see
page 386)
The CXPI, NFC, and MANChester functions are now available with
the educator's kit.
:FUNCtion<m>[:FFT]:WINDow
(see page 483)
The BARTlett window is now available.
:MEASure:DELay (see
page 580)
You can now specify an <edge_select_mode> with the command
and query.
:OPERegister:CONDition (see
page 280)
Bit 4 in the Operation Status Condition Register now shows
whether the remote user interface is enabled.