Keysight Technologies InfiniiVision 4000 X Series

68 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
1 What's New
:POWer:SIGNals:VSTeady :POWer:SIGNals:VSTeady:ONO
Ff:OFF (see page 790)
:POWer:SIGNals:VSTeady:ONO
Ff:ON (see page 791)
:POWer:SIGNals:VSTeady:TRA
Nsient (see page 792)
This command was separated
into several other commands
for specific types of power
analysis.
:POWer:SLEW:VALue none Slew rate values are now
displayed using max and min
measurements of a
differentiate math function
signal.
:PWRenable none The Power Event Enable
Register does not exist in the
4000 X-Series oscilloscopes.
:PWRRegister[:EVENt] none The Power Event Event
Register does not exist in the
4000 X-Series oscilloscopes.
:TRIGger:USB:SOURce:DMINus none These USB trigger commands
are superseded by commands
that are available with the USB
2.0 Full/Low Speed or USB 2.0
High Speed serial decode and
triggering licenses. See
":SBUS<n>:USB
Commands" on page 1112.
:TRIGger:USB:SOURce:DPLus none
:TRIGger:USB:SPEed none
:TRIGger:USB:TRIGger none
Discontinued Command Current Command Equivalent Comments