Keysight Technologies InfiniiVision 4000 X Series - Page 243

Common (*) Commands 6
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 243
*RCL (Recall)
(see page 1610)
Command Syntax
*RCL <value>
<value> ::= {0|1|2|3|4|5|6|7|8|9}
The *RCL command restores the state of the instrument from the specified
save/recall register.
See Also • "Introduction to Common (*) Commands" on page 231
• "*SAV (Save)" on page 247