520 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
21 :HARDcopy/:HCOPY Commands
:HARDcopy:STARt
(see page 1610)
Command Syntax
:HARDcopy:STARt
The :HARDcopy:STARt command starts a print job.
See Also • "Introduction to :HARDcopy Commands" on page 504
• ":HARDcopy:APRinter" on page 507
• ":HARDcopy:PRINter:LIST" on page 519
• ":HARDcopy:FACTors" on page 508
• ":HARDcopy:FFEed" on page 509
• ":HARDcopy:INKSaver" on page 510
• ":HARDcopy:LAYout" on page 511
• ":HARDcopy:PALette" on page 518
To Next Page
Loading...
