Keysight Technologies InfiniiVision 4000 X Series User Manual

:LISTer Commands 22
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 525
:LISTer:DISPlay
(see page 1610)
Command Syntax
:LISTer:DISPlay <value>
<value> ::= {{OFF | 0} | {SBUS1 | ON | 1} | {SBUS2 | 2} | ALL}
The :LISTer:DISPlay command configures which of the serial buses to display in
the Lister, or whether the Lister is off. "ON" or "1" is the same as "SBUS1".
When set to "ALL", the decode information for different buses is interleaved in
time.
Serial bus decode must be on before it can be displayed in the Lister.
Query Syntax
:LISTer:DISPlay?
The :LISTer:DISPlay? query returns the Lister display setting.
Return Format
<value><NL>
<value> ::= {OFF | SBUS1 | SBUS2 | ALL}
See Also • "Introduction to :LISTer Commands" on page 523
• ":SBUS<n>:DISPlay" on page 856
• ":LISTer:DATA" on page 524

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English