Keysight Technologies InfiniiVision 4000 X Series

:FUNCtion<m> Commands 20
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 493
Query Syntax :FUNCtion<m>:OPERation?
The :FUNCtion<m>:OPERation? query returns the current operation for the
selected function.
Return Format
<operation><NL>
<operation> ::= {ADD | SUBT | MULT | DIV | INT | DIFF | FFT | FFTP
| SQRT | MAGN | ABS | SQU | LN | LOG | EXP | TEN | LOWP | HIGH
| AVER | SMO | ENV | LIN | MAX | MIN | PEAK | MAXH | MINH | TREN
| BTIM | BST}
See Also • "Introduction to :FUNCtion<m> Commands" on page 460
• ":FUNCtion<m>:DISPlay" on page 469
• "*OPC (Operation Complete)" on page 240
• ":FUNCtion<m>:SOURce1" on page 498
• ":FUNCtion<m>:SOURce2" on page 500
• ":FUNCtion<m>:INTegrate:IOFFset" on page 486
• ":FUNCtion<m>[:FFT]:SPAN" on page 480
• ":FUNCtion<m>[:FFT]:CENTer" on page 471
• ":FUNCtion<m>[:FFT]:PHASe:REFerence" on page 477
• ":FUNCtion<m>[:FFT]:VTYPe" on page 482
• ":FUNCtion<m>[:FFT]:WINDow" on page 483
• ":FUNCtion<m>:LINear:GAIN" on page 487
• ":FUNCtion<m>:LINear:OFFSet" on page 488
• ":FUNCtion<m>:FREQuency:LOWPass" on page 485
• ":FUNCtion<m>:FREQuency:HIGHpass" on page 484
• ":FUNCtion<m>:AVERage:COUNt" on page 462
• ":FUNCtion<m>:SMOoth:POINts" on page 497
• ":FUNCtion<m>:TRENd:NMEasurement" on page 501
• ":FUNCtion<m>:BUS:YINCrement" on page 465
• ":FUNCtion<m>:BUS:YORigin" on page 466
• ":FUNCtion<m>:BUS:YUNits" on page 467
• ":FUNCtion<m>:BUS:CLOCk" on page 463
• ":FUNCtion<m>:BUS:SLOPe" on page 464
NOTE
If a math function is on (see :FUNCtion<m>:DISPlay), changing the operator will cause an
automatic vertical scaling of the new math function waveform. If you wait for the operation to
complete (with an *OPC? query for example), then query the math functions's scale, you can
see the vertical scaling that was automatically determined.