4 Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
• Chapter 10, “:CALibrate Commands,” starting on page 331, describes utility
commands for determining the state of the calibration factor protection button.
• Chapter 11, “:CHANnel<n> Commands,” starting on page 343, describes
commands that control all oscilloscope functions associated with individual
analog channels or groups of channels.
• Chapter 12, “:COMPliance Commands,” starting on page 367, describes
commands that control the USB 2.0 signal quality analysis feature.
• Chapter 13, “:COUNter Commands,” starting on page 379, describes
commands that control the counter analysis feature.
• Chapter 14, “:DEMO Commands,” starting on page 385, describes commands
that control the education kit demonstration signals that can be output on the
oscilloscope's Demo 1 and Demo 2 terminals.
• Chapter 15, “:DIGital<d> Commands,” starting on page 393, describes
commands that control all oscilloscope functions associated with individual
digital channels.
• Chapter 16, “:DISPlay Commands,” starting on page 401, describes commands
that control how waveforms, graticule, and text are displayed and written on
the screen.
• Chapter 17, “:DVM Commands,” starting on page 427, describes commands
that control the digital voltmeter analysis feature.
• Chapter 18, “:EXTernal Trigger Commands,” starting on page 433, describes
commands that control the input characteristics of the external trigger input.
• Chapter 19, “:FRANalysis Commands,” starting on page 439, describes
commands that control oscilloscope functions associated with the Frequency
Response Analysis (FRA) feature, which is available is with the license-enabled
built-in waveform generator).
• Chapter 20, “:FUNCtion<m> Commands,” starting on page 455, describes
commands that control math waveforms.
• Chapter 21, “:HARDcopy/:HCOPY Commands,” starting on page 503,
describes commands that set and query the selection of hardcopy device and
formatting options.
• Chapter 22, “:LISTer Commands,” starting on page 523, describes commands
that turn on/off the Lister display for decoded serial data and get the Lister
data.
• Chapter 23, “:MARKer Commands,” starting on page 527, describes commands
that set and query the settings of X-axis markers (X1 and X2 cursors) and the
Y-axis markers (Y1 and Y2 cursors).
• Chapter 24, “:MEASure Commands,” starting on page 549, describes
commands that select automatic measurements (and control markers).
• Chapter 25, “:MEASure Power Commands,” starting on page 641, describes
measurement commands that are available when the power measurements and
analysis application is licensed and enabled.
To Next Page
Loading...
Need help?
General
