Keysight Technologies InfiniiVision 4000 X Series User Manual

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 5
• Chapter 26, “:MTESt Commands,” starting on page 665, describes commands
that control the license-enabled mask test feature.
• Chapter 27, “:POD Commands,” starting on page 699, describes commands
that control all oscilloscope functions associated with groups of digital
channels.
• Chapter 28, “:POWer Commands,” starting on page 705, describes commands
that control the license-enabled power measurement application.
• Chapter 29, “:RECall Commands,” starting on page 809, describes commands
that recall previously saved oscilloscope setups, reference waveforms, or
masks.
• Chapter 30, “:SAVE Commands,” starting on page 821, describes commands
that save oscilloscope setups, screen images, and data.
• Chapter 31, “:SBUS<n> Commands,” starting on page 853, describes
commands that control oscilloscope functions associated with the serial
decode bus and serial triggering.
• Chapter 32, “:SEARch Commands,” starting on page 1149, describes
commands that control oscilloscope functions associated with searching for
waveform events.
• Chapter 33, “:SYSTem Commands,” starting on page 1259, describes
commands that control basic system functions of the oscilloscope.
• Chapter 34, “:TIMebase Commands,” starting on page 1281, describes
commands that control all horizontal sweep functions.
• Chapter 35, “:TRIGger Commands,” starting on page 1295, describes
commands that control the trigger modes and parameters for each trigger
type.
• Chapter 36, “:WAVeform Commands,” starting on page 1393, describes
commands that provide access to waveform data.
• Chapter 37, “:WGEN<w> Commands,” starting on page 1431, describes
commands that control waveform generator (Option WGN) functions and
parameters.
• Chapter 38, “:WMEMory<r> Commands,” starting on page 1481, describes
commands that control reference waveforms.
• Chapter 39, “Obsolete and Discontinued Commands,” starting on page 1491,
describes obsolete commands which still work but have been replaced by
newer commands and discontinued commands which are no longer supported.
• Chapter 40, “Error Messages,” starting on page 1549, lists the instrument error
messages that can occur while programming the oscilloscope.
The command descriptions in this reference show upper and lowercase characters.
For example, :AUToscale indicates that the entire command name is :AUTOSCALE.
The short form, :AUT, is also accepted by the oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:

Keysight Technologies InfiniiVision 4000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 4000 X Series
Category	Test Equipment
Language	English