Siemens SINAMICS S110 - 1.1 Overview of parameters; 1.1.1 Explanation of list of parameters

Parameter
Overview of parameters
1-12
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
1.1 Overview of parameters
1.1.1 Explanation of list of parameters
Basic structure of parameter descriptions
The data in the following example has been chosen at random. The table below
contains all the information that can be included in a parameter description. Some
of the information is optional.
The parameter list (See Chapter 1.2) is structured as follows:
- - - - - - - - - - - - - - - - - - - - Start of example- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Description: Text
Values: 0: Name and meaning of value 0
1: Name and meaning of value 1
2: Name and meaning of value 2
etc.
Recommenda-
tion:
Text
Index: [0] = Name and meaning of index 0
[1] = Name and meaning of index 1
[2] = Name and meaning of index 2
etc.
Dependency: Text
See also: pxxxx, rxxxx
See also: Fxxxxx, Axxxxx
Note: Information which might be useful
- - - - - - - - - - - - - - - - - - - - End of example- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
pxxxx[0...n] BICO: Full parameter name/Abbreviated name
Drive object (func-
tion module)
Can be changed: C1(x), C2(x), U, T Calculated: CALC_MOD_REG Access level: 2
Data type: Unsigned32/Integer16 Dynamic index: CDS, p0170 Function diagram: 2080
P group: Control Unit group: 7_1 Unit selection: p0505
Not for motor type: FEM Scaling: p2000 Expert list: 1
Min Max Factory setting
0.00 [Nm] 10.00 [Nm] 0.00 [Arms]
Bit array: Bit Signal name 1 signal 0 signal FP
00 Name and meaning of bit 0 Yes No 8010
01 Name and meaning of bit 1 Yes No -
02 Name and meaning of bit 2 Yes No 8012
etc.
Danger: WARNING: Caution: Safety notices with a warning triangle
Caution: Notice: Safety notices without a warning triangle