Siemens SINAMICS S110 - r8930[0...239] PN Name of Station active; PN Name Stat act; r8931[0...3] PN IP Address of Station active; PN IP of Stat act; r8932[0...3] PN Default Gateway of Station active; PN Def Gateway act; r8933[0...3] PN Subnet Mask of Station active; PN Subnet Mask act

List of parameters
Parameter
1-527
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Description: Displays the active station name for the onboard PROFINET interface on the Control Unit.
Description: Displays the active IP address for the onboard PROFINET interface on the Control Unit.
Description: Displays the active default gateway for the onboard PROFINET interface on the Control Unit.
Description: Displays the active subnet mask for the onboard PROFINET interface on the Control Unit.
Description: Displays the MAC address for the onboard PROFINET interface on the Control Unit.
r8930[0...239] PN Name of Station active / PN Name Stat act
CU_S110-PN Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8931[0...3] PN IP Address of Station active / PN IP of Stat act
CU_S110-PN Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8932[0...3] PN Default Gateway of Station active / PN Def Gateway act
CU_S110-PN Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8933[0...3] PN Subnet Mask of Station active / PN Subnet Mask act
CU_S110-PN Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8935[0...5] PN MAC Address of Station / PN MAC of Station
CU_S110-PN Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dynamic index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -