Siemens SINAMICS S110 - Fig. 2-100 3095 - Generating the speed limits (r0108.8 = 0)

Setpoint channel not activated
Function diagrams
2-863
© Siemens AG 2012 All Rights Reserved SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Fig. 2-100 3095 – Generating the speed limits (r0108.8 = 0)
- 3095 -
Function diagram
87654321
fp_3095_98_eng.vsd
DO: SERVO
SINAMICS S110
30.09.11 V04.04.00
Setpoint channel not activated - Generating the speed limits (r0108.8 = 0)
[3020.6]
[3060.4]
[3070.4]
[5300.1]
<1> With OFF1/OFF3, the deceleration ramp of the basic ramp-function generator is active (p1135 or p1121).
<100> Applies only if the function module "expanded setpoint channel" (r0108.8 = 0) is not active. For r0108.8 = 1, [3050] applies instead of [3095].
n_limit neg
-210 000.000...0.000 rpm
p1086[D] (-210 000.000)
Reference value for the ramp-function generator
Max
-1
Min
<1>
<100>
n_limit pos
0.000...210 000.000 rpm
p1083[D] (210 000.000)
Maximum speed
0.000...210 000.000 rpm
p1082[D] (1500.000)
Speed limits if a setpoint channel
has not been activated
(r0108.8 = 0).
0
0
p1083[D]
n_limit pos
p1086[D]
n_limit neg
4000.00 μs
[5030.5]
[5210.1]
[8010.2]
r1084
n_limit pos eff
[5030.5]
[5210.1]
[8010.2]
r1087
n_limit neg eff