Keysight Technologies InfiniiVision 4000 X Series

Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide 9
*OPT (Option Identification) / 241
*RCL (Recall) / 243
*RST (Reset) / 244
*SAV (Save) / 247
*SRE (Service Request Enable) / 248
*STB (Read Status Byte) / 250
*TRG (Trigger) / 252
*TST (Self Test) / 253
*WAI (Wait To Continue) / 254
7 Root (:) Commands
:ACTivity / 259
:AER (Arm Event Register) / 260
:AUToscale / 261
:AUToscale:AMODE / 263
:AUToscale:CHANnels / 264
:AUToscale:FDEBug / 265
:BLANk / 266
:DIGitize / 268
:HWEenable (Hardware Event Enable Register) / 270
:HWERegister:CONDition (Hardware Event Condition Register) / 272
:HWERegister[:EVENt] (Hardware Event Event Register) / 273
:MTEenable (Mask Test Event Enable Register) / 274
:MTERegister[:EVENt] (Mask Test Event Event Register) / 276
:OPEE (Operation Status Enable Register) / 278
:OPERegister:CONDition (Operation Status Condition Register) / 280
:OPERegister[:EVENt] (Operation Status Event Register) / 283
:OVLenable (Overload Event Enable Register) / 286
:OVLRegister (Overload Event Register) / 288
:PRINt / 290
:RUN / 291
:SERial / 292
:SINGle / 293
:STATus / 294
:STOP / 295
:TER (Trigger Event Register) / 296
:VIEW / 297
8 :ACQuire Commands
:ACQuire:AALias / 302
:ACQuire:COMPlete / 303