Dell Force10 Z9000 - Banner Motd

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced the keyword keyboard-interactive.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information
A login banner message is displayed only in EXEC Privilege mode after entering the enable
command followed by the password. These banners are not displayed to users in EXEC mode.
Example
FTOS(conf)#banner login ?
keyboard-interactive Press enter key to get prompt
LINE c banner-text c, where 'c' is a delimiting character
FTOS(conf)#no banner login ?
keyboard-interactive Prompt will be displayed by default
<cr>
FTOS(conf)#banner login keyboard-interactive
Enter TEXT message. End with the character '%'.
This is the banner%
FTOS(conf)#end
FTOS#exit
13d21h9m: %RPM0-P:CP %SEC-5-LOGOUT: Exec session is terminated
for user on line console
This is the banner
FTOS con0 now available
Press RETURN to get started.
13d21h10m: %RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful
for user on line console
This is the banner
FTOS>
Related
Commands
banner motd – sets a Message of the Day banner.
exec-banner – enables the display of a text string when you enter EXEC mode.
banner motd
Set a message of the day (MOTD) banner.
C-Series, E-Series, S-Series, Z-Series
Syntax
banner motd c line c
Parameters
c Enter a delineator character to specify the limits of the text banner.
The delineator is a percent character (%).
100