Dell Force10 Z9000 - Show Ip Bgp Inconsistent-As

Field Description
From Displays the IP address of the neighbor advertising the flapping
route.
Flaps Displays the number of times the route flapped.
Duration Displays the hours:minutes:seconds since the route first flapped.
Reuse Displays the hours:minutes:seconds until the flapped route is
available.
Path Lists all the ASs the flapping route passed through to reach the
destination network.
Example
FTOS>show ip bgp flap
BGP table version is 210851, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Flaps Duration Reuse
Path
FTOS>
show ip bgp inconsistent-as
View routes with inconsistent originating autonomous system (AS) numbers; that is, prefixes that are announced from
the same neighbor AS but with a different AS-Path.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip bgp [ipv4 unicast] inconsistent-as
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp inconsistent-as command shown in the
Example below.
Field
Description
Network Displays the destination network prefix of each BGP route.
400