debug gvrp
Enable debugging on GVRP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the no debug gvrp {config | events | pdu}
command.
Parameters
config Enter the keyword config to enable debugging on the GVRP
configuration.
event Enter the keyword event to enable debugging on the JOIN/LEAVE
events. Not available on the S4810.
pdu Enter the keyword pdu followed one of the following Interface
keywords and slot/port or number information:
Not available on the S4810.
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
Defaults Disabled.
Command Modes EXEC
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
651
To Next Page
Loading...
