Dell Force10 Z9000 - Default Vlan-ID

Defaults none
Command Modes INTERFACE VLAN
Command History
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 6.3.1.1 Introduced on the E-Series.
Related
Commands
show vlan – displays the VLAN configuration.
default vlan-id
Specify a VLAN as the Default VLAN.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
default vlan-id vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the no
default vlan-id
vlan-id syntax.
Parameters
vlan-id Enter the VLAN ID number of the VLAN to become the new Default
VLAN. The range is 1 to 4094. The default is 1.
Defaults The Default VLAN is VLAN 1.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id 1).
The Default VLAN contains only untagged interfaces.
Related
Commands
interface vlan – configures a VLAN.
939