distance ospf
Configure an OSPF distance metric for different types of routes.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
distance ospf [external dist3] [inter-area dist2] [intra-area
dist1]
To delete these settings, use the no distance ospf command.
Parameters
external
dist3
(OPTIONAL) Enter the keyword external followed by a number to
specify a distance for external type 5 and 7 routes. The range is 1 to
255. The default is 110.
inter-area
dist2
(OPTIONAL) Enter the keywords inter-area followed by a number
to specify a distance metric for routes between areas. The range is 1
to 255. The default is
110.
intra-area
dist1
(OPTIONAL) Enter the keywords intra-area followed by a number
to specify a distance metric for all routes within an area. The range is
1 to 255. The default is 110.
Defaults
• external
dist3
= 110
• inter-area
dist2
= 110
• intra-area
dist1
= 110
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
To specify a distance for routes learned from other routing domains, use the redistribute
command.
distribute-list in
Apply a filter to incoming routing updates from OSPF to the routing table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
distribute-list prefix-list-name in [interface]
1048
To Next Page
Loading...
