disable
Globally disable GVRP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults Enabled.
Command Modes CONFIGURATION-GVRP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Related
Commands
gvrp enable – enables GVRP on physical interfaces and LAGs.
protocol gvrp – access GVRP protocol.
garp timers
Set the intervals (in milliseconds) for sending GARP messages.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave |
leave-all} command.
Parameters
join Enter the keyword join followed by the number of milliseconds to
configure the join time. The range is 100 to 147483647 milliseconds.
The default is 200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave followed by the number of milliseconds to
configure the leave time. The range is 100 to 2147483647 milliseconds.
The default is 600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all Enter the keywords leave-all followed by the number of
milliseconds to configure the leave-all time. The range is 100 to
2147483647 milliseconds. The default is 1000 milliseconds.
652
To Next Page
Loading...
