show linecard boot-information
View the line card status and boot information.
E-Series
Syntax
show linecard boot-information
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 6.5.1.4 Introduced on the E-Series.
Usage
Information
show linecard
boot-
information
Field
Description
# Displays the line card slot numbers, beginning with slot 0. The
number of slots listed is dependent on your chassis: 0 to 13 on the
E1200, 0 to 13 on the E1200, 0 to 5 on the E300.
Status Indicates if a line card is online, offline, or booting. If a line card is
not detected in the slot, a hyphen ( - ) is displayed.
CurType Displays the line card identification number;, for example, EXW4PF.
Serial number Displays the line card serial number.
Booted from Indicates whether the line card cache booted or system booted. In
addition, the image with which the line card booted is also displayed.
• If the line card cache booted, the output is A: or B: followed
by the image in the flash partition (A: 6.5.1.4 or B: 6.5.1.4).
• If the line card system booted, the display is the current
FTOS version number (6.5.1.4).
Next boot Indicates if the next line card boot is a cache boot or system boot
and which image is used in the boot.
Cache boot Displays the system image in cache boot flash partition A: and B: for
the line card. If the cache boot does not contain a valid image,
“invalid” is displayed.
Boot flash Displays the two possible Boot flash versions. The [b] next to the
version number is the current boot flash, that is the image used in
the last boot.
The display area of this command uses the maximum 80 character length. If your display area
is not set to 80 characters, the display wraps.
153
To Next Page
Loading...
