Dell Force10 Z9000 - Redistribute

• For a Port Channel interface, enter the keyword port-channel
followed by a number:
– C-Series, Z-Series, and S4810. Range: 1-128
– E-Series 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Defaults Enabled, that is sending of routing updates are enabled by default.
Command Modes
ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command History
Version 9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
By default, no interfaces are passive . Routing updates are sent to all interfaces on which the
routing protocol is enabled.
If you disable the sending of routing updates on an interface, the particular address prefix will
continue to be advertised to other interfaces, and updates from other routers on that interface
continue to be received and processed.
OSPFv3 for IPv6 routing information is neither sent nor received through the specified router
interface. The specified interface address appears as a stub network in the OSPFv3 for IPv6
domain.
redistribute
Redistribute into OSPFv3.
C-Series, E-Series, Z-Series, S4810
Syntax
redistribute {bgp as number}{connected | static}[metric metric-
value | metric-type type-value] [route-map map-name] [tag tag-
value]
To disable redistribution, use the no redistribute {connected | static} command.
Parameters
bgp as number
Enter the keyword bgp followed by the autonomous system number.
Range: 1 to 65535.
connected
Enter the keyword connected to redistribute routes from physically
connected interfaces.
static
Enter the keyword static redistribute manually configured routes.
metric metric-
value
Enter the keyword metric followed by the metric value.
Range: 0 to 16777214
1119