Dell Force10 Z9000 - Upgrade Fpga-Image

may *
* cause a board RMA. Proceed with caution ! *
***********************************************************
Restore fpga image for linecard 4 [yes/no]: yes
FPGA restore in progress. Please do NOT power off the card.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Linecard 4 FPGA restore successful.
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
Related
Commands
reset – resets a card.
upgrade fpga-image
Upgrade the primary FPGA image.
C-Series
Syntax
upgrade fpga-image {rpm {number | all}| linecard {number | all}
[system-fpga | link-fpga] | all} {booted | file-url}
Parameters
rpm number Enter the keyword rpm followed by the RPM slot number to upgrade
an RPM FPGA The range is 0 to 1.
linecard number Enter the keyword linecard followed by the line card slot number
to upgrade a linecard FPGA. The range is 0 to 7 on the C300 and 0 to 3
on the C150.
all Enter the keyword all to upgrade all RPM and linecard FPGAs.
Enter the keyword all after the keyword rpm to upgrade all FPGAs
on all RPMs.
Enter the keyword all after the keyword linecard to upgrade all
FPGAs on all linecards.
system-fpga (OPTIONAL) Enter the keywords system-fpga to upgrade only the
system FPGA on a fiber linecard.
NOTE: Contact Dell Force10 TAC before using this keyword.
link-fpga (OPTIONAL) Enter the keywords link-fpga to upgrade only the
link FPGA on a fiber linecard.
NOTE: Contact the Dell Force10 TAC before using this keyword.
booted Upgrade the FPGA image using the currently running FTOS image.
94