Dell Force10 Z9000 - Debug Ip Bgp Updates

NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group followed by the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view BGP notifications received
from neighbors.
out (OPTIONAL) Enter the keyword out to view BGP notifications sent to
neighbors.
Command Modes EXEC Privilege
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
Enter the no debug ip bgp command to remove all configured debug commands for BGP.
debug ip bgp updates
Allows you to view information about BGP updates.
C-Series, E-Series
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name | ipv6
unicast [ipv6-address]] updates [in | out | prefix-list prefix-
list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name | ipv6 unicast [ipv6-address]] updates [in |
out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format followed by
the prefix length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group followed by the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view BGP updates received
from neighbors.
out (OPTIONAL) Enter the keyword out to view BGP notifications
updates sent to neighbors.
Command Modes EXEC Privilege
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
475