Dell Force10 Z9000 - Write

Related
Commands
ip address – assigns a primary and secondary IP address to the interface.
write
Copy the current configuration to either the startup-configuration file or the terminal.
C-Series, E-Series, S-Series, Z-Series
Syntax
write {memory | terminal}
Parameters
memory Enter the keyword memory to copy the current running configuration
to the startup configuration file. This command is similar to the copy
running-config startup-config command.
terminal Enter the keyword terminal to copy the current running
configuration to the terminal. This command is similar to the show
running-config command.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
The write memory command saves the running-configuration to the file labeled startup-
configuration. When using a LOCAL CONFIG FILE other than the startup-config not named
“startup-configuration” (for example, you used a specific file during the
boot config
command), the running-config is not saved to that file; use the copy command to save any
running-configuration changes to that local file.
Related
Commands
save – saves configurations created in BOOT_USER mode (BLI).
193