set tag
Configure a filter to specify a tag for redistributed routes.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set tag tag-value
To delete a setting, use the no set tag command.
Parameters
tag-value
Enter a number as the tag. The range is zero (0) to 4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set automatic-tag – computes the tag value of the route.
set level – specifies the OSPF area for route redistribution.
set metric – specifies the metric value assigned to redistributed routes.
set metric-type – specifies the route type assigned to redistributed routes.
set weight
Configure a filter to add a non-RFC compliant attribute to the BGP route to assist with route selection.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set weight weight
To delete a weight specification, use the no set weight weight command.
Parameters
weight
Enter a number as the weight to be used by the route meeting the
route map specification. The range is 0 to 65535. The default is router-
originated = 32768 and all other routes = 0.
When there are multiple routes to the same destination, routes with a
higher weight are preferred.
Defaults router-originated = 32768; all other routes = 0
301
To Next Page
Loading...
