To return to the default values, use the no max-age command.
Parameters
max-age
Enter a number of seconds the FTOS waits before refreshing
configuration information. The range is 6 to 40 seconds. The default is
20 seconds.
Defaults 20 seconds
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Related
Commands
forward-delay – changes the wait time before RSTP transitions to the Forwarding state.
hello-time – changes the time interval between BPDUs.
protocol spanning-tree rstp
Enter RSTP mode to configure RSTP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
protocol spanning-tree rstp
To exit RSTP mode, use the exit command.
Defaults Not configured
Command Modes CONFIGURATION RSTP (conf-rstp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use
the no disable command from RSTP mode.
Example
FTOS(conf)#protocol spanning-tree rstp
FTOS(config-rstp)##no disable
1278
To Next Page
Loading...
