Dell Force10 Z9000 - Default Logging Trap; Logging

default logging trap
Return to the default settings for logging messages to the Syslog servers.
C-Series, E-Series, S-Series, Z-Series
Syntax
default logging trap
Defaults level = 6 or informational
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
logging trap – limit messages logged to the Syslog servers based on severity.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple logging servers of
both IPv4 and/or IPv6 can be configured.
C-Series, E-Series, S-Series, Z-Series
Syntax
logging {ipv4-address | ipv6-address | hostname}
To disable logging, use the no logging command.
Parameters
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) address.
hostname Enter the name of a host already configured and recognized by the
switch.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.1.0 Added support for IPv6.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
1382