Dell Force10 Z9000 - Neighbor Default-Originate

To return to the default value, use the no neighbor {ip-address | peer-group-
name} allowas-in command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name Enter the name of the peer group to set the advertisement interval for
all routers in the peer group.
number Enter a number of times to allow this neighbor ID to use the AS path.
The range is 1 to 10.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Related
Commands
bgp four-octet-as-support – enables 4-Byte support for the BGP process.
neighbor default-originate
Inject the default route to a BGP peer or neighbor.
C-Series, E-Series
Syntax
neighbor {ipv6-address | peer-group-name} default-originate
[route-map map-name]
To remove a default route, use the no neighbor {ipv6-address | peer-group-
name
} default-originate [route-map map-name] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name Enter the name of the peer group to set the advertisement interval for
all routers in the peer group.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
481