Dell Force10 Z9000 - Sflow Extended-Router Enable

extended-switch Enter the keywords extended-switch to collect extended switch
information.
enable Enter the keyword enable to enable global extended information.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
The show sflow command displays the configured global extended information.
FTOS 7.8.1.0 and later enhances the sFlow implementation for real time traffic analysis on the
E-Series to provide extended gateway information in cases where the destination IP addresses
are learned by different routing protocols and for cases where the destination is reachable
over ECMP.
Example
FTOS#show sflow
sFlow services are enabled
Global default sampling rate: 64
Global default counter polling interval: 1000
Global extended information enabled: gateway, router, switch
1 collectors configured
Collector IP addr: 20.20.20.2, Agent IP addr: 10.11.201.7, UDP
port: 6343
1732336 UDP packets exported
0 UDP packets dropped
12510225 sFlow samples collected
0 sFlow samples dropped due to sub-sampling
FTOS#
Related
Commands
show sflow – displays the sFlow configuration.
sflow extended-router enable
Enable packing information on a router and switch.
E-Series
Syntax
sflow extended-router [extended-switch] enable
To disable packing information, use the no sflow extended-router [extended-
switch] enable command.
Parameters
extended-switch Enter the keywords extended-switch to collect extended switch
information.
enable Enter the keyword enable to enable global extended information.
1353